When you start researching ways to reduce your commercial sewer bill, you’ll encounter several terms that sound similar but mean different things. Sewer credits, sewer exemptions, and sewer rate adjustments each work differently, and using the wrong terminology when talking to your utility can lead to confusion \u2014 or worse, applying for the wrong program entirely.<\/p>\n
A sewer credit reduces your sewer charges proportionally based on the volume of water you can document as non-sewer use. You still pay sewer charges \u2014 just on a smaller volume. For example, if your building uses 500,000 gallons per month and you can prove 150,000 gallons evaporate through your cooling tower, you receive a credit that removes those 150,000 gallons from your sewer calculation. You pay sewer on the remaining 350,000 gallons.<\/p>\n
Sewer credits are the most common mechanism for cooling tower facilities because the credit amount adjusts with your actual water use. During summer months when your tower runs harder and evaporates more, your credit is larger. During winter when the tower is idle or running at reduced capacity, the credit reflects that lower evaporation.<\/p>\n
A sewer exemption removes sewer charges entirely for water flowing through a specific meter or pipe. The most common example is a dedicated irrigation meter<\/strong> \u2014 a separate water meter that serves only landscape irrigation. Since irrigation water soaks into the ground and never reaches the sewer, the entire volume measured by that meter is exempt from sewer billing.<\/p>\n Exemptions are simpler than credits because there’s no calculation needed \u2014 if water goes through the exempt meter, it has zero sewer charges. The EPA’s guidance on outdoor water use<\/a> notes that landscape irrigation is one of the largest uses of water in commercial properties, making dedicated irrigation meters a valuable complement to cooling tower credits.<\/p>\n A sewer rate adjustment changes how<\/em> your sewer rate is calculated rather than reducing the volume. Some utilities offer industrial or commercial rate classes with lower per-gallon sewer rates for facilities that meet certain criteria. Others allow you to petition for a custom sewer-to-water ratio \u2014 for example, if you can demonstrate that only 70 percent of your purchased water reaches the sewer, the utility may permanently set your sewer billing at 70 percent of water volume.<\/p>\n Rate adjustments are less common than credits but can be more valuable for facilities with consistent, predictable water use patterns.<\/p>\n For most commercial buildings with cooling towers, sewer credits<\/strong> are the right mechanism. Here’s why: cooling tower evaporation varies seasonally, so a proportional credit that adjusts with your metered data gives you the most accurate \u2014 and usually the largest \u2014 reduction. Our guide to qualifying for sewer credits<\/a> walks through the specific requirements for cooling tower facilities.<\/p>\n That said, many facilities benefit from multiple<\/em> programs simultaneously. A building with both a cooling tower and significant landscaping might have a sewer credit for evaporation losses and a sewer exemption via a dedicated irrigation meter. The two programs stack, and together they can reduce sewer charges by 30 to 50 percent. The Department of Energy<\/a> recommends a comprehensive approach to water management that accounts for all non-sewer uses, not just the largest one.<\/p>\n When you contact your utility, using the right term gets you to the right department and the right application. Asking about “sewer exemptions” when you really need “sewer credits” might lead a customer service representative to tell you there’s no program available \u2014 when there actually is, just under a different name. If your first call doesn’t yield results, try all three terms. For a detailed look at how different cities handle these programs, see our breakdown of utility billing assumptions<\/a>.<\/p>\n RPM Water Equity Solutions helps commercial facilities recover money lost to sewer billing assumptions. If your building has cooling towers, you may be paying sewer charges on water that never reaches the sewer system.<\/p>\nRate Adjustment: A Different Calculation Method<\/h2>\n
Which One Applies to Your Cooling Tower?<\/h2>\n
Why the Terminology Matters<\/h2>\n
Ready to Find Out What You Could Save?<\/h3>\n